Pulled the trans again after verifying that my slave cylinder was at the end of its stroke. Turned out I needed to reset the self adjusting...
To clarify I put in a new clutch disc but had the pressure plate and flywheel resurfaced by a machine shop, it looked fine with no broken or...
Wow this truck is about to get scrapped, flipped the disc around and still is doing the same thing. Any ideas?
I put a new clutch in too, and will be putting a new master in this afternoon since the plastic pushrod broke on me. I found out that I put the...
I had my engine (3.0) out to replace the rear main seal and oil pan gasket and also threw in a new slave cylinder since the bearing felt a little...
You can definitely catch a fingernail in them. Not sure if I was losing oil pressure through them, but they are scored up decently bad. I...
Just bought a 2000 ranger, 3.0 5 speed 4wd but the oil pan gasket was leaking like crazy so I pulled the engine to replace it, the clutch, and the...
Separate names with a comma.
